Lookah Q7 Mini E-Nail Kit - V0558

Lookah Q7 Mini E-Nail Banger Kit

The Lookah Q7 Mini E-Nail banger is smaller, sleeker, and easier to use than the previous Lookah E-nails. It features a 950mAh battery that offers between 80 to 100 uses on a single charge and a 710-thread quartz atomizer for a better taste profile. It fits four different coil types allowing ultimate versatility for heat and flavor. Like its predecessor, the Q7 mini will fit most 14mm to 18mm pipes. A silicon sheath for the downstem allows for use with smaller joint pipes, which can be removed when using the enail banger with larger dab rigs. 

The three voltage settings (Mode 1: 3.2V, Mode 2: 3.6V and Mode 3: 4.0V.) on the Q7 mini can be adjusted with a double click of the power button. These settings adjust the temperature between 350 to 450 degrees Fahrenheit. Intuitive digital display shows battery charge and mode.

How to Use the Q7 Mini E-Nail

1. Place the Q7 mini into the downstem of your water pipe. 
2. Open the magnetic flip cap and place a small amount of wax into the center of the atomizer coil. 
3. Close the flip-cap
4. Press the power button 5 times within 2 seconds to turn on the Q7 Mini enail. 
5. The device will enter a preheat mode, and the display will show a countdown from 9 to 0 as the preheat is active. 
6. After the preheat has finished, the light will flash 2 times. 
7. Click the power button 2 times to select the voltage mode. The mode will be indicated by a 1, 2, or 3 on the display screen. 
8. Press and hold the power button for up to 30 seconds to heat the atomizer and vaporize the wax. 
9. Inhale from the mouthpiece of the water pipe. You can adjust the airflow by covering the carb on the flip cap as required. 

Be sure to wipe around the atomizer to remove any excess wax and turn the device off after you have finished using it. 

How to Clean the Q7 Mini E-Nail

1. Open the magnetic carb lid.
2. Remove the 710 thread atomizer by unscrewing it counterclockwise.
3. Remove the downstem by unscrewing it clockwise.
4. Use the cleaning brush and some isopropyl alcohol to clean the airway between the downstem and atomizer coil. 
5. With some isopropyl and a Q-tip, swab out the area around where the 710 coils would screw into the device.
6. Swab out the atomizer coil with a Q-tip after each session.
7. Clean around the carb cap and the device's body with a damp cloth, and dry well afterward. 
8. When dry, reassemble the parts.

Kit comes with

• 1 Enail Dab kit
• 2 Quartz Atomizer Coil (Type A, 710 thread)
• 1 Silicon sleeve
• 1 User Manual

Specifications/Features

• Battery: 950mAh
• Auto Preheat
• Easy to Clean
• Replaceable 710 Coils
• Three voltage settings

MSRP: $79.99